The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    T500 Palm Rest Questions

    Discussion in 'Lenovo' started by sjk09, Aug 21, 2009.

  1. sjk09

    sjk09 Notebook Enthusiast

    Reputations:
    0
    Messages:
    21
    Likes Received:
    0
    Trophy Points:
    5
    I just replaced my ram today, and as I was putting the palm rest back on, the third screw from the left wouldn't tighten unless I put pressure against the palm rest as I screwed it in. Is this normal or did I do something wrong?

    Also, does anyone else have a clicking noise when pushing the palm rest above the third USB port?
     
    sjk09, Aug 21, 2009
    #1
  2. StealthTH

    StealthTH Notebook Evangelist

    Reputations:
    281
    Messages:
    680
    Likes Received:
    0
    Trophy Points:
    30
    Not too sure on locations since port outlet on my T400 is a bit different. The clicking noise is normal though because the palmrest snaps in place as well as being secured by screws. Sounds normal to me.
     
    StealthTH, Aug 21, 2009
    #2