The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Will I be able to upgrade my T61p CPU from a C2D T7500 to a C2D T7700 or C2D T7800?

    Discussion in 'Lenovo' started by SkeeteRX8, Nov 8, 2007.

  1. SkeeteRX8

    SkeeteRX8 Notebook Deity

    Reputations:
    124
    Messages:
    1,063
    Likes Received:
    0
    Trophy Points:
    55
    I have a question about upgrading my CPU in my Thinkpad T61p, a C. Though it runs extremely well now, usually at 2.15-2.2 ghz, would I be able (for further futureproofing) to later on replace it with a T7700 or T7800 processor provided I had the correct BIOS and such, since all are from the same series of Merom processors and are all listed as T61p processor options on the site?

    If so, would there also be anything else I would need to do?
     
  2. philfna

    philfna Notebook Evangelist NBR Reviewer

    Reputations:
    160
    Messages:
    532
    Likes Received:
    0
    Trophy Points:
    30
    I owuld imagine since they are the same pinout you'd be fine. The next series of processors probably will not work though.
     
  3. chubbyfatazn

    chubbyfatazn Notebook Evangelist

    Reputations:
    87
    Messages:
    590
    Likes Received:
    0
    Trophy Points:
    30
    Yeah, you can. I don't think that the processors are soldered onto the board in this case.

    Given your already-high spec machine, I would say that no further things to do or check for, once the processor has been popped in.

    Edit: Per the poster above, I thought that Penryn chips were for Socket P also...
     
  4. vespoli

    vespoli 402 NBR Reviewer

    Reputations:
    1,134
    Messages:
    3,401
    Likes Received:
    0
    Trophy Points:
    105
    It would be a plug-and-play replacement. However, given the level of your machine, you're not going to be needing to replace any time soon, nor will you notice too much of a difference unless you're crunching a HUGE amount of numbers.

    It would also void your warranty.
     
  5. philfna

    philfna Notebook Evangelist NBR Reviewer

    Reputations:
    160
    Messages:
    532
    Likes Received:
    0
    Trophy Points:
    30
    Forgot that Vespoli's correct -- I doubt if you are using 100 percent of the processing power of your current unit.
     
  6. SkeeteRX8

    SkeeteRX8 Notebook Deity

    Reputations:
    124
    Messages:
    1,063
    Likes Received:
    0
    Trophy Points:
    55
    Nope, not at all...

    I was just worried about how well it would perform in the future....even though its great already... (my last Thinkpad was an X22, BIG difference)

    Thanks though.
     
  7. eyecon82

    eyecon82 Notebook Deity

    Reputations:
    70
    Messages:
    1,800
    Likes Received:
    0
    Trophy Points:
    55
    replacing processors is very difficult, even though it is plug and play..you would have to remove palm rest, KB, the keyboard bezel, the network card, the cooling system, to finally get to the CPU...there's a switch you have to turn in order to pop out the old cpu...it will void your warranty, and unless you know what you are doing, you will probably end up frying your system. Also, many don't install the cooling system back no properly relating to heat issues, since thermal grease is required. i ahvea t7300 and I do A LOT of multitasking without overloading my cpu...unless you're doing mathlab.or some other cpu intensive programs, this is unnecessary