so i was putting a PNY 1gb ddr2 5300 stick in my t61
but for some reason i couldn't fit it in
when i took out the original stick on the bottom i noticed that
the spaces didn't line up and i couldn't get it in the upper level.
am i doing it wrong or is the stick bad? most likely i'm doing it wrong
thanks
-
Check out these videos for RAM installation: http://www-307.ibm.com/pc/support/site.wss/MIGR-63959.html
-
try to take out ur installed memory. is it exactly at the same size with ur new memory ?
-
well the lengths are the same but the space toward the right side is a little off
-
Can you take a picture?
Tim -
Sounds like its the wrong type of RAM -- did you order/receive PC2-5300?
-
Make sure it's 200 pin also.
memory install problem
Discussion in 'Lenovo' started by fortzum, Dec 25, 2007.