The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Need Help on resetting bios for GT627

    Discussion in 'MSI' started by Rurouni24354, Jul 16, 2011.

  1. Rurouni24354

    Rurouni24354 Newbie

    Reputations:
    0
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    5
    Hi! I accidentally changed the graphic setting in bios on the northbridge from PEG/PCI to PCI/PEG. Now there is no display but the notebook still boot up.

    What would be the best way to change it back?
    Resetting bios, or can someone post the picture of bios menus so that I can change it back somehow?

    Thank you very much
     
    Rurouni24354, Jul 16, 2011
    #1
  2. robm@rkcomputer.net

    [email protected] Company Representative

    Reputations:
    492
    Messages:
    1,079
    Likes Received:
    0
    Trophy Points:
    55
    Pull the CMOS battery, i'm pretty sure it is under the wireless card. This should reset the bios to default settings. Leave it disconnected for about 30 seconds.
     
    [email protected], Jul 17, 2011
    #2