The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Do I need updated AGA driver?

    Discussion in 'Other Manufacturers' started by BaroqueJim, May 3, 2005.

  1. BaroqueJim

    BaroqueJim Notebook Geek

    Reputations:
    46
    Messages:
    80
    Likes Received:
    0
    Trophy Points:
    15
    I installed the latest from the Averatec website before I did my factory restore - now I'm wondering whether I should do it again. Last time, I had to install the new one to up my AGP speed to 8x. This time, I just installed the Catalyst drivers, modded by the Patje modding tool, and without updating my AGP drivers, the AGP speed is nonetheless set at 8x now.

    So is there any point me updating the AGP driver? And if so, how do I go about removing all traces of the new one? Where is it located?
     
    BaroqueJim, May 3, 2005
    #1
  2. wolfskinbjc

    wolfskinbjc Notebook Geek

    Reputations:
    21
    Messages:
    93
    Likes Received:
    0
    Trophy Points:
    15
    I've updated to the newest version of the agp driver at www.sis.com , It will not let me turn the agp speed to anything but 0x. Thats pathetic, if u've installed the latest catalyst with mobility modder, and have the averatec agp driver installed, in my much researched and tried opinion, you have the best driver set up out for the 6100.

    Wolfskin
     
    wolfskinbjc, May 3, 2005
    #2