The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Key sequence to restore factory defaults

    Discussion in 'Other Manufacturers' started by mugiwara, Sep 14, 2009.

  1. mugiwara

    mugiwara Notebook Guru

    Reputations:
    0
    Messages:
    55
    Likes Received:
    0
    Trophy Points:
    15
    Hello
    Can someone tell me the key sequence to enter bios, load factory settings, save and reboot ?

    My 6224w went black without notice, just a few months and 2 years from its purchase date. It's probably the notorious Nvidia bug but I'd like to everything before contacting Zepto.
    Thanks
     
    mugiwara, Sep 14, 2009
    #1
  2. Megatron

    Megatron Notebook Consultant

    Reputations:
    0
    Messages:
    112
    Likes Received:
    0
    Trophy Points:
    30
    Your sceen is all black? Could it be a loose wire somewhere?
     
    Megatron, Sep 15, 2009
    #2
  3. mugiwara

    mugiwara Notebook Guru

    Reputations:
    0
    Messages:
    55
    Likes Received:
    0
    Trophy Points:
    15
    well I'd like to verify that hypothesis as well, only I don't know where the cables run to the screen and how to access them.
    Mind you, I tried to hook an external LCD and switch the display (because I can still start WinXP fine) without success, so I doubt it's a cable problem...
     
    mugiwara, Sep 15, 2009
    #3