The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    SXS37 fingerprint reader

    Discussion in 'Other Manufacturers' started by chelet, May 10, 2008.

  1. chelet

    chelet Notebook Deity

    Reputations:
    170
    Messages:
    1,501
    Likes Received:
    0
    Trophy Points:
    55
    Is it possible to configure the SXS37 without the fingerprint reader, or to get it placed somewhere other than between the right- and left-click buttons?

    Can you get it with a silver keyboard instead of a black one?
     
    chelet, May 10, 2008
    #1
  2. ivang

    ivang Company Representative

    Reputations:
    90
    Messages:
    290
    Likes Received:
    0
    Trophy Points:
    0
    No but youcan always use the FP Scanner as a scrolling device too.

    Only black on those keyboard still.
     
    ivang, May 12, 2008
    #2
  3. dylanemcgregor

    dylanemcgregor Notebook Consultant

    Reputations:
    20
    Messages:
    212
    Likes Received:
    0
    Trophy Points:
    30
    How is this done. I haven't seen this in the configuration (but I haven't looked very hard either).
     
    dylanemcgregor, May 12, 2008
    #3
  4. ivang

    ivang Company Representative

    Reputations:
    90
    Messages:
    290
    Likes Received:
    0
    Trophy Points:
    0
    It's in the UPEK Fingerprint Suite
     
    ivang, May 13, 2008
    #4
  5. dylanemcgregor

    dylanemcgregor Notebook Consultant

    Reputations:
    20
    Messages:
    212
    Likes Received:
    0
    Trophy Points:
    30
    I have UPEK FIngerprint Sensor in the control panel, but can't find a mention of UPEK anywhere else on my system. The control panel doesn't have any options, just a version tab and a sensor tab. Would this software be on one of the discs sent with my system that I'd need to install myself?
     
    dylanemcgregor, May 13, 2008
    #5
  6. ivang

    ivang Company Representative

    Reputations:
    90
    Messages:
    290
    Likes Received:
    0
    Trophy Points:
    0
    Its the program you setup your fingers with, did you remove it by chance? If yes you would need to re-install it; send and email to support@portableone to get the program.
     
    ivang, May 13, 2008
    #6
  7. dylanemcgregor

    dylanemcgregor Notebook Consultant

    Reputations:
    20
    Messages:
    212
    Likes Received:
    0
    Trophy Points:
    30
    Thanks Ivan. I'll email support.
     
    dylanemcgregor, May 14, 2008
    #7