The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    CF-29 Touchscreen Calibration

    Discussion in 'Panasonic' started by GFPD1, Sep 9, 2009.

  1. GFPD1

    GFPD1 Newbie

    Reputations:
    0
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    5
    Recently sent a CF-29 in for replacement of the touchscreen. Before sending it back they called and said they were unable to calibrate the TC and needed to reload a base image.

    I received the unit back from repair and loaded my own image. Of course, the TC now works perfectly but I am unable to calibrate it. The calibration program runs, but the TC does not work during calibration. It works fine everywhere else.

    Is there a way to reinstall only the calibration program?
     
    GFPD1, Sep 9, 2009
    #1
  2. Toughbook

    Toughbook Drop and Give Me 20!

    Reputations:
    1,267
    Messages:
    7,361
    Likes Received:
    370
    Trophy Points:
    251
    Where did you send the CF-29 for the replacement touchscreen?

    Yes... You should be able to go to the websites posted in the stickies at the top of the forum and finf the Mouse/touchscreen drivers for your application. Then go into Device Manager and uninstall the one you have... Then reinstall the one you downloaded.

    Sounds weird to me...
     
    Toughbook, Sep 9, 2009
    #2