The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    CF-30 GOBI Install Problems!

    Discussion in 'Panasonic' started by TOPGUN1, Nov 7, 2009.

  1. TOPGUN1

    TOPGUN1 Newbie

    Reputations:
    0
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    5
    Need Help!
    Just got a GOBI (30GOBIFU) WWAN card for my CF-30FTSAXAM Toughbook and can't get the system to recognize it. My Toughbook was a wireless ready unit when I purchased it but the system just doesn’t see it. Installing the card was very easy as far as inserting into the unit. The system configuration doesn’t even show it is installed. What I’m I doing wrong?
    Thanks for any help!
     
    TOPGUN1, Nov 7, 2009
    #1
  2. Toyo

    Toyo Notebook Deity

    Reputations:
    305
    Messages:
    1,258
    Likes Received:
    36
    Trophy Points:
    66
    Check out the BIOS 1st. Make sure everything is enabled @ hit F10. Do you have the Gobi disc, or did you load the CSA from Panny support?

    When you do get the hardware figured out, then load the software, you will come to a screen that asks you where you want to install it. Be sure and pick HDD. It makes the installation much easier. From there just follow the questions. Just be sure to extract it 1st, then open up CSASETUP.EXE. Which carrier are you going with, or have an account with?
     
    Toyo, Nov 7, 2009
    #2