The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Fingerprint reader door fix?

    Discussion in 'Panasonic' started by Stewboy, May 27, 2020.

  1. Stewboy

    Stewboy Notebook Consultant

    Reputations:
    0
    Messages:
    202
    Likes Received:
    20
    Trophy Points:
    31
    The cover/door on the fingerprint reader I recently installed will close, but the "latch"--a little rubber nib, or nub, that snaps under the lip of the reader frame--is barely locking in place. I thought about adding a tiny dot of something--superglue, epoxy, etc. . . to increase its profile enough to make it latch more securely but wanted to see if any of you have other solutions. Thanks.
     
    Stewboy, May 27, 2020
    #1