I’m trying to set up a modem so I can use the gps with the existing antenna, as featured here
http://forum.notebookreview.com/threads/fz-g1-mc7700-gps-antenna.826385/
...but I can’t figure out how toe where to enter these magical commands in windows 10. Can someone show me the way?
im on an fz-G1 with a new 7355 wwan card. I can get a gps signal, but it’s weak, probably because there’s no antenna attached to the gps connector. The link above gives the commands to tell the modem to use the main antenna for gps, which would be really nice.
-
Thanks. Is there an address or directory I need to send the commands to?
-
HyperTerminal sends your AT commands to COM port of your modem.
-
Understood. Thank you
How do I enter AT! Commands in W10?
Discussion in 'Panasonic' started by CF30Medic, Jun 19, 2021.