The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Accessing the mother board in Sager NP7155

    Discussion in 'Sager and Clevo' started by Doomdev, Jul 26, 2015.

  1. Doomdev

    Doomdev Newbie

    Reputations:
    0
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    5
    I recently purchased a Sager NP7155 from Xoticpc and already had an M.2 SSD to install in it. When I got the laptop the bottom panel was all one solid piece and even after removing all the screws it won't come loose. I have never disassembled a laptop before and this is my first Sager so I was just wondering if anybody knew how to get it loose so I can install my SSD. Any help you could provide would be greatly appreciated!

    Thank you,
    Devon
     
    Doomdev, Jul 26, 2015
    #1
  2. t456

    t456 1977-09-05, 12:56:00 UTC

    Reputations:
    1,959
    Messages:
    2,588
    Likes Received:
    2,048
    Trophy Points:
    181
    See its Service Manual (Clevo N155SD); Chapter 2: Disassembly. Pretty straightforward, just never omit removing battery; should always be the first step.
     
    t456, Jul 26, 2015
    #2
    Bullrun likes this.