The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Best GPU OC software and GPU screws

    Discussion in 'Sager and Clevo' started by kevindd992002, Jul 11, 2009.

  1. kevindd992002

    kevindd992002 Notebook Virtuoso

    Reputations:
    233
    Messages:
    2,299
    Likes Received:
    5
    Trophy Points:
    56
    What is the best OC software for my 9800M GTS?

    And where can I find the 4 small silver screws that screws the heatsink of my M860TU to the GPU itself? My current screws are almost unscrewable by a screw driver since their + form is almost wearing out because of excessive force I've used in unscrewing and screwing them back on :(
     
    kevindd992002, Jul 11, 2009
    #1
  2. The_Moo™

    The_Moo™ Here we go again.....

    Reputations:
    3,973
    Messages:
    13,930
    Likes Received:
    0
    Trophy Points:
    455
    The_Moo™, Jul 11, 2009
    #2
  3. Soviet Sunrise

    Soviet Sunrise Notebook Prophet

    Reputations:
    2,140
    Messages:
    6,547
    Likes Received:
    0
    Trophy Points:
    205
    The four screws that hold down the GPU are the same as the black screws that hold down the hard drive bracket and the same as the screw that holds down mini PCI-e cards such as the wireless card. You can ask your reseller to send you a few replacement ones. Also, make sure you use the proper bit, specifically the PH0 size crosshead bit.
     
    Soviet Sunrise, Jul 11, 2009
    #3
  4. kevindd992002

    kevindd992002 Notebook Virtuoso

    Reputations:
    233
    Messages:
    2,299
    Likes Received:
    5
    Trophy Points:
    56
    Ah. When you say bit, are you referring to the screwdriver tool size?
     
    kevindd992002, Jul 11, 2009
    #4