The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    CPUgenie does not work with X9100 & 5795??

    Discussion in 'Sager and Clevo' started by Adorex, Sep 14, 2009.

  1. Adorex

    Adorex Notebook Guru

    Reputations:
    0
    Messages:
    62
    Likes Received:
    0
    Trophy Points:
    15
    I'v purchased this program, ran the auto undervolt, and now that I have everything setup, the voltages that are set in cpugenie are not being used by the CPU.

    Any ideas on what to do?

    I've already turned off any bios overclocking, but that did not change anything, and there are no other similar programs running.
     
    Adorex, Sep 14, 2009
    #1
  2. theriko

    theriko Ronin

    Reputations:
    1,303
    Messages:
    2,923
    Likes Received:
    4
    Trophy Points:
    56
    It works fine on my 5793, what program are you using to monitor voltages?

    Do you have greenvoltage and cpu power management turned on and all the required states set, and the correct power profile set in cpu genie?
     
    theriko, Sep 15, 2009
    #2
  3. Adorex

    Adorex Notebook Guru

    Reputations:
    0
    Messages:
    62
    Likes Received:
    0
    Trophy Points:
    15
    Yes, everything in the program is set and I'm using the same program to monitor voltages and cpu speeds.
     
    Adorex, Sep 15, 2009
    #3