The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Can't remove CPU heatsink off M570RU-U

    Discussion in 'Sager and Clevo' started by hannibal90210, Dec 30, 2010.

  1. hannibal90210

    hannibal90210 Newbie

    Reputations:
    0
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    5
    Forgive me if this has been asked about before, I just can't seem to find anything relevant.

    I'm trying to upgrade my CPU and am unable to remove the heatsink from the corner of the laptop.

    After removing the 3 screws around the CPU, the service manual (M57RU_SM4.pdf) simply states to "Carefully lift the heat sink (Figure 6c) up and off the computer".

    The problem is, the copper block between the fan and vent is stuck on what looks like a piece of black plastic on the left hand side. It allows the block to side forwards and back but won't allow me to lift it, I can only angle it up.

    This is sooooooo frustrating. Anyone familiar with this issue able to guide me in the right direction?

    stuck-cpu-heatsink.jpg
     
    hannibal90210, Dec 30, 2010
    #1
  2. hannibal90210

    hannibal90210 Newbie

    Reputations:
    0
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    5
    Not to worry, I'm such a noob... Managed to get it out in the end by removing the top of the fan casing (held by 4 screws).
     
    hannibal90210, Dec 30, 2010
    #2
  3. theriko

    theriko Ronin

    Reputations:
    1,303
    Messages:
    2,923
    Likes Received:
    4
    Trophy Points:
    56
    Glad you sorted it, though I don't remember having to take the cover off, I thought I just wiggled it a bit.
     
    theriko, Dec 30, 2010
    #3