The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Chicony 300 Watt PSU For X7200 - Useful For Other Clevos?

    Discussion in 'Sager and Clevo' started by gizmo22, Aug 19, 2012.

  1. gizmo22

    gizmo22 Notebook Consultant

    Reputations:
    0
    Messages:
    147
    Likes Received:
    46
    Trophy Points:
    41
    I currently have two 300 watt Chicony power supplies, model CPA09-022A, being used via bridge with my NP7280.

    I am currently looking at getting rid of it in favor of a smaller 15" Sager. The NP9150 is of most interest, but I am curious if I can use the 300 watt Chicony with the NP9150 (or any other current model Sager)?

    Thanks!
     
    gizmo22, Aug 19, 2012
    #1
  2. pau1ow

    pau1ow Notebook Deity

    Reputations:
    1,336
    Messages:
    1,181
    Likes Received:
    84
    Trophy Points:
    66
    No the 4-pin DIN connector on your 300W PSU don't fit the P150EM power socket, though it should fit the P170EM 4-pin DIN female connector.
     
    pau1ow, Aug 19, 2012
    #2
  3. gizmo22

    gizmo22 Notebook Consultant

    Reputations:
    0
    Messages:
    147
    Likes Received:
    46
    Trophy Points:
    41

    This makes it mighty compelling to go with a P170EM instead....or hope I can find someone to trade a 300 watt 4 din for the 180 or 220 for a P150em
     
    gizmo22, Aug 19, 2012
    #3