The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Clevo W860CU software (or commands) for hardware buttons

    Discussion in 'Sager and Clevo' started by NadJ, Feb 23, 2012.

  1. NadJ

    NadJ Newbie

    Reputations:
    0
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    5
    Hi all,

    I always hit the 'Slow' hardware button when my laptop boots up cos like most people I rarely need that much power and the added quietness also helps but now that I run pretty much docked 75-80% of the time I was wondering if there was software or some kind of command I could issue to have this be the default mode of operation?

    Anyone?
    Thanks
     
    NadJ, Feb 23, 2012
    #1