I am not very experienced in this, but I went ahead, watched some guides and applied some new thermal paste to my new Clevo150EM (specifically Artic Silver).
The stock job was, a little iffy... Again, i dont have a lot of experience here, but the paste was overflowing over the sides of both the GPU and the CPU, whereas most of the guides I watched showed a nice spread around the middle of the unit.
Long story short, I applied the paste, played some CS:GO, let it idle some and then took a screen of the max/min CPU temps.
Image: ImageShack® - Online Photo and Video Hosting
Would someone mind taking a look at the screen and letting me know whether or not they think hose temps are in a healthy range.
Thanks.
-
looks fine to me
i got a 2860QM in a P150HM (see sig), pasted with OCZ Freeze and i also get max. temps in the 70s under full load.
cheers -
-
Mine is a 2670QM, and my temps are pretty similar to yours. My max temp is 75 but my min temp is usually around 43-45, which is a little bit higher -.-
-
thats alright tho,my idle temps also hover around the 40s,depending on what im doing. the shown high 30s min temps would only occur for like a second before jumping into the 40s again. either that or ull just reach those by doing literally nothing with ur computer (empty desktop, no input, etc.), so no worries mate
doesnt get any better than this without fn+1 enabled
Sent from my GT-I9001 using Tapatalk 2
Clevo150EM CPU Temps Check
Discussion in 'Sager and Clevo' started by kinki, May 6, 2012.