The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Custom Clevo Cooling Board

    Discussion in 'Sager and Clevo' started by Calibre41, May 8, 2013.

  1. Calibre41

    Calibre41 Notebook Evangelist

    Reputations:
    547
    Messages:
    384
    Likes Received:
    4
    Trophy Points:
    31
    This thread may be a bit dormant for a while, it is my intention to design and manufacture a relatively simple design fan assisted cooling board for the Clevo's, I'm hoping 2 sizes will cover a range of Clevo's from the W110/W230 to the P15**M range.

    I want the cooling board to fit to the bottom of the Clevo casing, so its doesn't slide about when it's on your knee or desk, as this is a pet hate of mine.

    As this thread will be dormant for a while I would appreciate if you want to PM me registering interest I'll send a PM out via nbr as/when there's and update. I'll be getting a rough idea of the typical type of construction and sending it away for a quote to see how much it would cost to have "x" number made, the more people we might have on "board" ....... the cheaper it will be.

    Sorry about the cheap pun....:thumbsup:
     
    Calibre41, May 8, 2013
    #1
  2. Calibre41

    Calibre41 Notebook Evangelist

    Reputations:
    547
    Messages:
    384
    Likes Received:
    4
    Trophy Points:
    31
    Reserved :)
     
    Calibre41, May 8, 2013
    #2
  3. Calibre41

    Calibre41 Notebook Evangelist

    Reputations:
    547
    Messages:
    384
    Likes Received:
    4
    Trophy Points:
    31
    Because I can.... :D
     
    Calibre41, May 8, 2013
    #3