The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    D901C (Sager NP9262) LCD replacement/removal guide

    Discussion in 'Sager and Clevo' started by AndrewKW, Jun 10, 2009.

  1. AndrewKW

    AndrewKW Notebook Consultant

    Reputations:
    126
    Messages:
    231
    Likes Received:
    0
    Trophy Points:
    30
    Hello everyone
    My buddy scratched the LCD display and recieved replacement one.
    I did take a look on D901C service manual and there is not a word
    about LCD replacement process. Does anyone have step by step guide or any ideahow to remove and replace scratched glossy LCD panel ?


    Thanks everyone!!!
    (I think that gophn and other users with older D900 models might help as well)
     
    AndrewKW, Jun 10, 2009
    #1
  2. Gophn

    Gophn NBR Resident Assistant

    Reputations:
    4,843
    Messages:
    15,707
    Likes Received:
    3
    Trophy Points:
    456
    pretty simple actually.

    (just make sure you keep track of the screws)

    - remove battery
    - remove the small circle rubber and plastic covers on the LCD, which will exposed the screws under them
    - remove those screws
    - then you will have access to the LCD panel
    - remove the screws on the sides of the LCD (which are holding the panel down to the LCD's chassis hinges)
    - remove the LCD inverter

    Now you should have full access to remove/replace the LCD, then reverse the steps to put it all back together.
     
    Gophn, Jun 10, 2009
    #2