The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Firewire card in XR5 or Clevo D901C

    Discussion in 'Sager and Clevo' started by The Voyager, Aug 11, 2009.

  1. The Voyager

    The Voyager Notebook Consultant

    Reputations:
    0
    Messages:
    102
    Likes Received:
    2
    Trophy Points:
    31
    Does anyone knows what firewire is used in the XR5 or Clevo D901C
    I know it uses texas instruments drivers but don't know what card it actually is and would like to find out for troubleshooting spec's.

    Thanks
     
    The Voyager, Aug 11, 2009
    #1
  2. The Voyager

    The Voyager Notebook Consultant

    Reputations:
    0
    Messages:
    102
    Likes Received:
    2
    Trophy Points:
    31
    Bump...

    I figured that one out already, next I would need to know is if there is a way to put the firewire bus/card on it's own IRQ? The bios of the XR5/Clevo D901C is pretty much limited so i'm looking if theres a way to do this in the windows xp registry. Any info would be nice, cheers
     
    The Voyager, Aug 18, 2009
    #2