The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    M860TU. Increasing RAM voltage

    Discussion in 'Sager and Clevo' started by welshman, Apr 14, 2010.

  1. welshman

    welshman Notebook Enthusiast

    Reputations:
    10
    Messages:
    13
    Likes Received:
    0
    Trophy Points:
    5
    Has anyone succesfully modded the mobo in order to increase RAM voltage from 1.5v to say 1.6/1.7v?

    Ive been able to clock my P8400 and run a number of benchmarks at 2.6Ghz using setFSB and RMCLOCK whilst only occupying the top RAM slot. Im using PLL 1CS928BF-102 and maxing the mulitiplier to 8x. However, the lappy is not completely stable and will reboot on times.

    Im unable to use Thaiphoon Burner to edit the SPD on the RAM as it is write protected, and even if I could, relaxing the timings to allow the RAM to run at 1333Mhz will likely lead to no boot.

    Im thinking if I could increase the RAM voltage with a hardwire mod then I may be able to run my RAM at 1333.
     
    welshman, Apr 14, 2010
    #1