The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    NP2092 Monitor Turn Off Problem

    Discussion in 'Sager and Clevo' started by gonwk, Jul 5, 2008.

  1. gonwk

    gonwk Notebook Deity

    Reputations:
    343
    Messages:
    1,352
    Likes Received:
    0
    Trophy Points:
    55
    Hi folks, :)

    On my new Sager NP2092 for "Power Options" I have added 2 additional option ...

    Mode G2) to leave everything on ... never turn off Monitor or Hard Disk & never go Standby when Plgged In.

    Mode G1) to leave everything on ... never turn off Hard Disk & never go Standby, EXCEPT to turn off mu Monitor in 10 Minutes when Plgged In.

    And here is my problem (may be) ... I have been using Mode G1 successfully ... last couple of days. I just noticed that my monitor after 10 minutes goes Blank and immediately comes back on without me touching it ... that should not happen ...

    So, I changed the time from 10 minutes to 1 minute and worked just fine ... goes Black and Stays Black (OFF) until I touch the Touchpad ...

    I tried with different time minutes 2, 3, 4, 5, ... all worked ... BUT, when I go to 10 minutes the darn thing starts acting up ... just goes OFF momentarily and comes back on.

    Q: CAN ANYONE tell me what the heck is going on? DO I have a ghost in this thing!?!?

    Thanks,
    G! :confused:
     
    gonwk, Jul 5, 2008
    #1
  2. theriko

    theriko Ronin

    Reputations:
    1,303
    Messages:
    2,923
    Likes Received:
    4
    Trophy Points:
    56
    Have you tried 11 mins? Otherwise just use 9...
     
    theriko, Jul 6, 2008
    #2