The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    NP9850 users please help

    Discussion in 'Sager and Clevo' started by zl2bbl, Dec 29, 2009.

  1. zl2bbl

    zl2bbl Notebook Enthusiast

    Reputations:
    18
    Messages:
    40
    Likes Received:
    0
    Trophy Points:
    15
    Hi Guys,
    Im trying to load Win 7 on each of my three hard Drives.I can load it on
    two drives,those connected to P0 and P2.It wont go on P4 untill i physically
    remove that connected to P2.P2 and P4 are the ones housed in the dual carrier.Has anyone been able to do this.Have i got a problem,need confirmation from someone.
    Thanks
    Les
    P.S have tried two drives on this port,no luck.

    RESOLVED:
    Needed to put jumpers on end two pins(nearest edge of chassis).It forces it to scussi drive.WD mention it but Seagate just say its a factory setting.
     
    zl2bbl, Dec 29, 2009
    #1