The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.
← Previous page

    P870km /km1 coffelake support bios are on line now

    Discussion in 'Sager and Clevo' started by 52571abc, Jul 6, 2018.

  1. Dr. AMK

    Dr. AMK Living with Hope

    Reputations:
    3,961
    Messages:
    2,182
    Likes Received:
    4,654
    Trophy Points:
    281
    I already did that before start using it. anything more than 4.80ghz will get so hot.
    I'm happy with the huge performance improvement for the 8086K @4.70Ghz 6 cores than my 7700k, at this speed with some undervolting the heat will be within acceptable range.

    I need to test the Stock TM1 BIOS as well, as advised by respectable member.
     
    Dr. AMK, Sep 21, 2018
    #51
  2. Meaker@Sager

    Meaker@Sager Company Representative

    Reputations:
    9,436
    Messages:
    58,194
    Likes Received:
    17,909
    Trophy Points:
    931
    Past that it does get sample specific, mine runs about -125mv at 5ghz with the tm cooler.
     
    Meaker@Sager, Sep 21, 2018
    #52
    Dr. AMK likes this.
  3. Dr. AMK

    Dr. AMK Living with Hope

    Reputations:
    3,961
    Messages:
    2,182
    Likes Received:
    4,654
    Trophy Points:
    281
    I think mine can run the same if I can change the cooler, so the question is: can I replace the KM1 cooler with the TM1 cooler? is it needs any mods?

    Now I'm running at 4.80Ghs 1190v/-125, I succeed to render and gaming and the temps 81c max after 1 hour BF1.

    The BIOS I'm using now is the Stock TM1 BIOS, all cores appears correctly, and no issues so far, except the G.Sync is not available. I don't use it anyway. Until I can find a good BIOS mod that I can depend on.
     
    Dr. AMK, Sep 21, 2018
    #53
  4. Papusan

    Papusan Jokebook's Sucks! Dont waste your $$$ on Filthy

    Reputations:
    42,727
    Messages:
    29,853
    Likes Received:
    59,684
    Trophy Points:
    931
    You need the TM models Cpu backplate. Because the screw mounting piece is shorter on P870Tm models. Fully disassembly. + cut the pipes from the Gpu grid going to Cpu grill.
     
    Papusan, Sep 21, 2018
    #54
    Dr. AMK likes this.
  5. Meaker@Sager

    Meaker@Sager Company Representative

    Reputations:
    9,436
    Messages:
    58,194
    Likes Received:
    17,909
    Trophy Points:
    931
    The overall fit on height is a bit different so yes you need that back plate too.
     
    Meaker@Sager, Sep 21, 2018
    #55
    Dr. AMK likes this.
  6. Dr. AMK

    Dr. AMK Living with Hope

    Reputations:
    3,961
    Messages:
    2,182
    Likes Received:
    4,654
    Trophy Points:
    281
    Tell me what to do and what/where to buy and I'll just follow your instructions.
     
    Dr. AMK, Sep 21, 2018
    #56
  7. Papusan

    Papusan Jokebook's Sucks! Dont waste your $$$ on Filthy

    Reputations:
    42,727
    Messages:
    29,853
    Likes Received:
    59,684
    Trophy Points:
    931
    I don’t have it. + DM has 5v fans. Not much to buy here home. @bloodhawk have done the mod.

    Edid. And I mean @Prema put in a TM Mb.
     
    Papusan, Sep 21, 2018
    #57
    Dr. AMK likes this.
  8. Meaker@Sager

    Meaker@Sager Company Representative

    Reputations:
    9,436
    Messages:
    58,194
    Likes Received:
    17,909
    Trophy Points:
    931
    Reach out to a local reseller might be your best bet.
     
    Meaker@Sager, Sep 21, 2018
    #58
    Dr. AMK likes this.
  9. Dr. AMK

    Dr. AMK Living with Hope

    Reputations:
    3,961
    Messages:
    2,182
    Likes Received:
    4,654
    Trophy Points:
    281
    I'll try to contact him.

    I have a conversation with him today, and I'll ask him about that,

    We don't have any local resellers in the whole ME/Gulf region. Anything I need must be ordered from US, Europe or Chaina.
     
    Dr. AMK, Sep 21, 2018
    #59
  10. Dr. AMK

    Dr. AMK Living with Hope

    Reputations:
    3,961
    Messages:
    2,182
    Likes Received:
    4,654
    Trophy Points:
    281
    Can I have your Throttlestop and BIOS settings?
     
    Dr. AMK, Sep 22, 2018
    #60
  11. Meaker@Sager

    Meaker@Sager Company Representative

    Reputations:
    9,436
    Messages:
    58,194
    Likes Received:
    17,909
    Trophy Points:
    931
    I don't bother with throttlestop at this sort of frequency and I based the power settings off of Johnksss if you notice power throttling.
     
    Meaker@Sager, Sep 22, 2018
    #61
    Dr. AMK likes this.
  12. Dr. AMK

    Dr. AMK Living with Hope

    Reputations:
    3,961
    Messages:
    2,182
    Likes Received:
    4,654
    Trophy Points:
    281
    Okay, but the stock BIOS force the cash to be at the 40x and it should be -3 from the preferred speed, there is no option to set the cash ratio to be 47x for the 5.0Ghz for example. Or just keep the cash at 40x?

    Do you know where I can buy the TM1 CPU heatsink and backplate?
     
    Last edited: Sep 23, 2018
    Dr. AMK, Sep 22, 2018
    #62
  13. Meaker@Sager

    Meaker@Sager Company Representative

    Reputations:
    9,436
    Messages:
    58,194
    Likes Received:
    17,909
    Trophy Points:
    931
    IIRC that ratio was hard linked in the 7xxx and 8xxx series.
     
    Meaker@Sager, Sep 23, 2018
    #63
    Dr. AMK likes this.
  14. Rahego

    Rahego Notebook Consultant

    Reputations:
    77
    Messages:
    267
    Likes Received:
    136
    Trophy Points:
    56
    @52571abc could you tell me what kind of bugs does your modded version of bios have?

    So far i can see that only 4 cores visible in BIOS - and also no function to overclock processor in BIOS. Anything else? Please could you provide any additional information :) I would really like to give it a shot since there is g-sync :)
     
    Rahego, Oct 22, 2018
    #64
  15. Meaker@Sager

    Meaker@Sager Company Representative

    Reputations:
    9,436
    Messages:
    58,194
    Likes Received:
    17,909
    Trophy Points:
    931
    I would not expect thorough documentation from a project like this.
     
    Meaker@Sager, Oct 22, 2018
    #65
    Rahego likes this.
  16. Rahego

    Rahego Notebook Consultant

    Reputations:
    77
    Messages:
    267
    Likes Received:
    136
    Trophy Points:
    56
    Documentation is big word :) i was thinking more about some known bugs. If they won't be that bad than i think it's worthy to give it a shot.
     
    Rahego, Oct 23, 2018
    #66
  17. Dr. AMK

    Dr. AMK Living with Hope

    Reputations:
    3,961
    Messages:
    2,182
    Likes Received:
    4,654
    Trophy Points:
    281
    Finally I got all parts I need from sagernotebook.com , special thanks to Eng. @Meaker@Sager for his kind support. And thanks for all great and professional sales team. It was not expected to find the best prices for all parts with sagernotebook.com.
    They mad an exception for me coz my laptop is from HID not from them, and they allow me to buy and gives me all the services I need, this is so kind from them.
     
    Dr. AMK, Oct 24, 2018
    #67
    Papusan, jclausius and FTW_260 like this.
  18. Meaker@Sager

    Meaker@Sager Company Representative

    Reputations:
    9,436
    Messages:
    58,194
    Likes Received:
    17,909
    Trophy Points:
    931
    Glad you got it sorted :)

    It never hurts to ask.
     
    Meaker@Sager, Oct 24, 2018
    #68
    unreall, Papusan and Dr. AMK like this.
  19. unreall

    unreall Notebook Enthusiast

    Reputations:
    0
    Messages:
    19
    Likes Received:
    3
    Trophy Points:
    6
    Hey guys :)
    Can someone help me with that bios?
    Iam new to bios flashing on clevo.
    I have buyed a clevo p870km-g with 1080 and 7600k and need a bit advice what for programm i need for flash and the steps maybe :)
    Till now i was succsesful with flashing the bios from dsanke there was a good step for step how to flash turtorial but after flashing my 4k screen lost g-sync. So i flashed the backup on it again.
    I hope someone could help me :)
    at the moment the stock bios is on the chip.
     
    Last edited: Aug 27, 2019
    unreall, Aug 27, 2019
    #69
  20. unreall

    unreall Notebook Enthusiast

    Reputations:
    0
    Messages:
    19
    Likes Received:
    3
    Trophy Points:
    6
    Maybe u Can help me :)
     
    unreall, Aug 27, 2019
    #70
  21. unreall

    unreall Notebook Enthusiast

    Reputations:
    0
    Messages:
    19
    Likes Received:
    3
    Trophy Points:
    6
    Maybe u could help me?
     
    unreall, Aug 27, 2019
    #71
  22. unreall

    unreall Notebook Enthusiast

    Reputations:
    0
    Messages:
    19
    Likes Received:
    3
    Trophy Points:
    6
    Sorry for the replys but i dort know how to pm someone of you ^^
     
    unreall, Aug 27, 2019
    #72
  23. Meaker@Sager

    Meaker@Sager Company Representative

    Reputations:
    9,436
    Messages:
    58,194
    Likes Received:
    17,909
    Trophy Points:
    931
    The original reseller of the machine is the normal first step for support.
     
    Meaker@Sager, Aug 27, 2019
    #73
  24. unreall

    unreall Notebook Enthusiast

    Reputations:
    0
    Messages:
    19
    Likes Received:
    3
    Trophy Points:
    6
    Sry for my english but i think u miss understood me ^^
    My clevo works fine i only want to upgrade to an 8700k i7 but iam not sure how to flash it corect. And iam looking for someone advice to upgrade to that coffelake bios.
     
    unreall, Aug 27, 2019
    #74
  25. Meaker@Sager

    Meaker@Sager Company Representative

    Reputations:
    9,436
    Messages:
    58,194
    Likes Received:
    17,909
    Trophy Points:
    931
    You will loose g-sync, that's normal. You did it right the first time.
     
    Meaker@Sager, Aug 28, 2019
    #75
  26. Rahego

    Rahego Notebook Consultant

    Reputations:
    77
    Messages:
    267
    Likes Received:
    136
    Trophy Points:
    56
    If you want to use bios for 8th/9th gen and keep g-sync than you need to get screen from p870TM that is supporthing g-sync.

    All this bioses are just modified TM's bios to work on KM's machine.
     
    Rahego, Aug 28, 2019
    #76
  27. unreall

    unreall Notebook Enthusiast

    Reputations:
    0
    Messages:
    19
    Likes Received:
    3
    Trophy Points:
    6
    Last edited: Aug 28, 2019
    unreall, Aug 28, 2019
    #77
  28. Rahego

    Rahego Notebook Consultant

    Reputations:
    77
    Messages:
    267
    Likes Received:
    136
    Trophy Points:
    56
    Rahego, Sep 8, 2019
    #78
← Previous page