The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Question about putting 360 receiver in P150HM

    Discussion in 'Sager and Clevo' started by thenson88, Dec 11, 2011.

  1. thenson88

    thenson88 Newbie

    Reputations:
    0
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    5
    I like to game with a controller sometimes and would like to take the internals of my 360 wireless receiver and somehow fit them into my laptop.

    http://icptjacksparrow.files.wordpress.com/2010/10/10.jpg?w=300&h=225

    I would like to know if any of you would think it possible to connect the circuit board to the laptops mobo with the connector shown in the picture.

    Suggestion?
     
    thenson88, Dec 11, 2011
    #1
  2. mythlogic

    mythlogic Company Representative

    Reputations:
    1,238
    Messages:
    2,021
    Likes Received:
    277
    Trophy Points:
    101
    Thats a USB connector, yea with a custom mPICE adapter to expose USB and some soldering you could make a connector, you still have the issue of physically there isn't really room in the case to fit that PCB, but its possible.
     
    mythlogic, Dec 11, 2011
    #2