The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Question on cooling temp performance and sager 9260(d900c)

    Discussion in 'Sager and Clevo' started by midnitdragoon, Feb 22, 2009.

  1. midnitdragoon

    midnitdragoon Notebook Consultant

    Reputations:
    4
    Messages:
    270
    Likes Received:
    0
    Trophy Points:
    30
    im using the zalman-nc 2000

    It fits the size of the laptop which is 17 inches i think but am curious, when i place sager 9260 on mat... the 4 vents that take in air are before the area where the cooler releases air. If i want to get better temp cooling should i place the laptop lower so that laptop cooler air actually goes in directly?

    I know this sounds silly >_<

    So basically, should i line up the 4 fan vents underneath the laptop to the laptop coolers main cool air out-take area rather than being above the area where the cool air exits?
     
    midnitdragoon, Feb 22, 2009
    #1
  2. Doodles

    Doodles Starving Student

    Reputations:
    178
    Messages:
    880
    Likes Received:
    0
    Trophy Points:
    30
    yes and no... for super max performance of it, logically yes you should...
    but i have the NC2000.. and i did that, it does not make much of a difference. Just put the laptop rite where its supposed to. It'll drop your temps by a lot.. TRUST me
    in other words... no u dont have to line it up
     
    Doodles, Feb 22, 2009
    #2