The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Removing HS Assembly from 9800m GTX

    Discussion in 'Sager and Clevo' started by emike09, Jul 27, 2009.

  1. emike09

    emike09 Overclocking Champion

    Reputations:
    652
    Messages:
    1,840
    Likes Received:
    0
    Trophy Points:
    55
    I've been waiting a few days for an email from Sager with instructions on how to remove the HS Assembly from the 9800m GTX so that the card is bare. I can't wait any longer as dondahdah needs his card. Any ideas?
     
    emike09, Jul 27, 2009
    #1
  2. emike09

    emike09 Overclocking Champion

    Reputations:
    652
    Messages:
    1,840
    Likes Received:
    0
    Trophy Points:
    55
    Oops. Can I get a mod to move this to the Sager/Clevo forum? Thought I was already in there... :)
     
    emike09, Jul 27, 2009
    #2
  3. Soviet Sunrise

    Soviet Sunrise Notebook Prophet

    Reputations:
    2,140
    Messages:
    6,547
    Likes Received:
    0
    Trophy Points:
    205
    There are tabs located all around the copper heatcage. Use a flathead to carefully pry each tab out until you can pull the top half of the heatcage off.
     
    Soviet Sunrise, Jul 27, 2009
    #3
  4. crash

    crash NBR Assassin

    Reputations:
    2,221
    Messages:
    5,540
    Likes Received:
    13
    Trophy Points:
    206
    Thread moved :)
     
    crash, Jul 28, 2009
    #4