The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Sager 5620 Not Boot After CMOS Bat Install

    Discussion in 'Sager and Clevo' started by Syngensmyth, Jul 29, 2007.

  1. Syngensmyth

    Syngensmyth In All Seriousness

    Reputations:
    159
    Messages:
    1,125
    Likes Received:
    0
    Trophy Points:
    55
    I installed a new CMOS Bat and my 5620 won't boot ... no ... nothing. I'm out of ideas. Everything is plugged in. How does one do a CMOS clear on one of these things?

    Edit: I found it ... one of the little ribbon cables was not plugged in. I never unplugged it ... it must have pulled out when I split the machine so didn't think to replug.

    I would delete this but can't find the "delete" button.
     
    Syngensmyth, Jul 29, 2007
    #1