The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Sager NP8662 / Clevo M860TU LCD Screen

    Discussion in 'Sager and Clevo' started by ZeroT3K, Apr 9, 2011.

  1. ZeroT3K

    ZeroT3K Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    Hey there NBR,

    It's been awhile since I've been here. Last time was when I was asking for laptop recommendations. Was told that the Clevo M860TU would be perfect for me, and I wasn't let down. Best laptop I've used hands down.

    However, after a few years of amazing use, my LCD screen is starting to act all wonky. I have this single pixel width, vertical green line that appears on my screen. Also, I'll sometimes get pulsating scan lines every now and then.

    I was certain that it was a ribbon / connection issue, but even though I've made sure everything is hooked up and in place, I can't get rid of the problem.

    I can alleviate the issue slightly by finding certain angles to open the LCD screen to, or by very slightly (Trust me. Verrrrry slightly) "flexing" the LCD screen.

    So, I figure I'd come here for suggestions. I'm pretty sure I'll end up having to buy a new LCD screen, and I've found this one that I'm pretty interested in as it's actually an upgrade from my lower resolution of 1680 x 1050 to 1920 x 1200.

    PROSTAR M860TU LAPTOP LCD SCREEN 15.4" WUXGA GLOSSY CCFL $115

    I'm assuming ProStar's M860TU is the exact same thing as Sager's, just rebranded. Would this screen be a compatible buy if I can't fix the issues I have?

    Thanks again =)

    Edit: Actually just thought about this right after I submitted. Would going up to 1920 x 1200 be a wise decision based on the increased pixel quantity in regards to gaming? ie. Framerates and whatnot.

    Edit 2: Also, just to clarify, I've made sure this is an LCD screen problem. External monitors work perfectly fine. So the graphics card isn't wearing out. Yet, at least =P

    Last Edit: Everyone loves videos -> http://www.youtube.com/watch?v=bYh3avO81CA
     
  2. mmarchid

    mmarchid Notebook Evangelist

    Reputations:
    133
    Messages:
    496
    Likes Received:
    0
    Trophy Points:
    30
    They say it is, therefore it should be. You will be able to find out the LCD part number only just before it is being shipped (if you ask).
     
  3. ZeroT3K

    ZeroT3K Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    Thanks. Still hope I can fix it and avoid spending money, but it's good knowing they still sell the particular screen I need to replace it.
     
  4. niffcreature

    niffcreature ex computer dyke

    Reputations:
    1,748
    Messages:
    4,094
    Likes Received:
    28
    Trophy Points:
    116