The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    USB port has bad connection... Need to re-solder it.

    Discussion in 'Sager and Clevo' started by 4st3risk, Dec 15, 2012.

  1. 4st3risk

    4st3risk Notebook Evangelist

    Reputations:
    92
    Messages:
    414
    Likes Received:
    0
    Trophy Points:
    30
    It's the 2.0 one on the right side. What to disassemble to get to it and what not to?
    With back cover off it looked like I have to take everything off, including both heat sinks.
    I just don't want to take parts off that can be kept on.
     
    4st3risk, Dec 15, 2012
    #1
  2. jaybee83

    jaybee83 Biotech-Doc

    Reputations:
    4,125
    Messages:
    11,571
    Likes Received:
    9,151
    Trophy Points:
    931
    best to ask for a service manual from ur reseller or an nbr member here, if u really wanna do it urself. otherwise id recommend rmaing it in, especially since its surely still under warranty.

    Sent from my Galaxy Nexus using Tapatalk 2
     
    jaybee83, Dec 15, 2012
    #2
  3. Meaker@Sager

    Meaker@Sager Company Representative

    Reputations:
    9,436
    Messages:
    58,200
    Likes Received:
    17,911
    Trophy Points:
    931
    RMA for sure if it's under warranty, otherwise take everything apart slowly and be thorough, don't try skipping corners.
     
    Meaker@Sager, Dec 15, 2012
    #3