The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Wake on Lan - Clevo W860CU ?

    Discussion in 'Sager and Clevo' started by Tromens, Jul 7, 2011.

  1. Tromens

    Tromens Newbie

    Reputations:
    0
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    5
    Has anyone been able to successfully boot a w860cu using Wake On Lan by ethernet?
    I have not found any such option in the BIOS (which actually has VERY FEW options).

    The magic packet I send works just fine on my desktop (I had enabled WoL in the BIOS and forwarded to a door at the router).

    Please let me know if you know how to make it work.
     
    Tromens, Jul 7, 2011
    #1
  2. Anthony@MALIBAL

    Anthony@MALIBAL Company Representative

    Reputations:
    616
    Messages:
    2,771
    Likes Received:
    3
    Trophy Points:
    56
    You can find out pretty quick if the card supports it by going to control panel > network and sharing center > network connections > right click on local area connection, properties > configure > advanced. It should list a wake on lan option down there to enable if it's supported.

    BTW, while you're there (and if you've got gigabit) if you disable all the checksum and send offloads as well as flow control, you'll get much faster throughput.
     
    Anthony@MALIBAL, Jul 7, 2011
    #2