The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    biosoncam setup says need driver for USB 2.0

    Discussion in 'Sager and Clevo' started by dexgo, Mar 12, 2008.

  1. dexgo

    dexgo Freedom Fighter

    Reputations:
    320
    Messages:
    1,371
    Likes Received:
    2
    Trophy Points:
    56
    I am just getting all my drivers setup on my d901

    and when trying to get the bisoncam working. when I hit ctrl f10 it tries to install a device or something.

    then in the device manager there is a device called USB 2.0

    this is the camera.

    where do I get drivers for this?

    thanks much

    dex
     
    dexgo, Mar 12, 2008
    #1
  2. Shyster1

    Shyster1 Notebook Nobel Laureate

    Reputations:
    6,926
    Messages:
    8,178
    Likes Received:
    0
    Trophy Points:
    205
    Shyster1, Mar 13, 2008
    #2
  3. eleron911

    eleron911 HighSpeedFreak

    Reputations:
    3,886
    Messages:
    11,104
    Likes Received:
    7
    Trophy Points:
    456
    Lol, Eurocom didn`t send you the driver cd ? :D
    Try Sager`s site also, www.sagernotebook.com , it`s the same hardware after all.
     
    eleron911, Mar 13, 2008
    #3
  4. dexgo

    dexgo Freedom Fighter

    Reputations:
    320
    Messages:
    1,371
    Likes Received:
    2
    Trophy Points:
    56
    they did, but I didn't use it.

    I d/l all the drivers off the net.

    i figured it out.
     
    dexgo, Mar 13, 2008
    #4