The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.
← Previous page

    q6600 pin-modders, what is your idle and load temps in normal fans

    Discussion in 'Sager and Clevo' started by ARGH, May 6, 2008.

  1. ARGH

    ARGH Notebook Deity

    Reputations:
    391
    Messages:
    1,883
    Likes Received:
    24
    Trophy Points:
    56
    lapping is sort of pointless as thats where the thermal paste comes into play, to fill in the micro gaps and create the seal.
     
    ARGH, May 11, 2008
    #51
  2. eleron911

    eleron911 HighSpeedFreak

    Reputations:
    3,886
    Messages:
    11,104
    Likes Received:
    7
    Trophy Points:
    456
    Have you guys considered UnderVolting? It will drop the temps.
    Unless you`re OCing,that is.
     
    eleron911, May 11, 2008
    #52
  3. psycroptik

    psycroptik Notebook Consultant

    Reputations:
    117
    Messages:
    246
    Likes Received:
    0
    Trophy Points:
    30
    Its more to remove that silver/tin layer and get down to the straight copper.
     
    psycroptik, May 11, 2008
    #53
← Previous page