The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    sager 8170 - stuck on power saver mode in CCC and can't change?

    Discussion in 'Sager and Clevo' started by acdc303, Nov 12, 2011.

  1. acdc303

    acdc303 Notebook Enthusiast

    Reputations:
    0
    Messages:
    21
    Likes Received:
    0
    Trophy Points:
    5
    Hey guys, whether my laptop is plugged in or not, in the Catalyst Control Center, under power saver -> active power plan, it always reads: power saver. I can't figure out how to make it performance orientated. I have read on another thread power saver can decrease performance quite a bit.

    here's a pic. [​IMG]

    Uploaded with ImageShack.us
     
    acdc303, Nov 12, 2011
    #1
  2. Anthony@MALIBAL

    Anthony@MALIBAL Company Representative

    Reputations:
    616
    Messages:
    2,771
    Likes Received:
    3
    Trophy Points:
    56
    Do you have the hotkey drivers installed? Right click on those in the tray and make sure they're not set to power saver. Do the same for the Windows power saver. If that doesn't fix it, you can try reinstalling the AMD drivers/hotkey drivers as that should resolve it.
     
    Anthony@MALIBAL, Nov 12, 2011
    #2