The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    underperforming ssd or controller?

    Discussion in 'Sager and Clevo' started by junhan4, Jan 11, 2012.

  1. junhan4

    junhan4 Notebook Enthusiast

    Reputations:
    0
    Messages:
    47
    Likes Received:
    0
    Trophy Points:
    15
    hey all, ive got a p151 and i put in my old intel 320 80gb ssd and im not sure if its performing as it should.

    im getting average reads of 250mbps but writes of 80mbps on as ssd but very poor results in hdtach

    im using the intel rst drivers and windows 7 64bit, ssdtoolbox trim optimised, sectors are aligned, everything im sure i did right.

    ssdsa2cw080g3 is my model.

    any ideas?
     
    junhan4, Jan 11, 2012
    #1
  2. junhan4

    junhan4 Notebook Enthusiast

    Reputations:
    0
    Messages:
    47
    Likes Received:
    0
    Trophy Points:
    15
    oh and when i set my power mode to high performance i get worse results, its really puzzling.
     
    junhan4, Jan 11, 2012
    #2
  3. Support.3@XOTIC PC

    Support.3@XOTIC PC Company Representative

    Reputations:
    1,268
    Messages:
    7,186
    Likes Received:
    1,002
    Trophy Points:
    331
    Looks like you're pretty close to where you should be. That SSD is rated at up to 270MBs read/ 90MBs write.

    Try some different benchmark programs. I perosnally like ATTO Disk Benchmark
     
    Support.3@XOTIC PC, Jan 11, 2012
    #3
  4. junhan4

    junhan4 Notebook Enthusiast

    Reputations:
    0
    Messages:
    47
    Likes Received:
    0
    Trophy Points:
    15
    ahh thats a relief, cheers mate
     
    junhan4, Jan 11, 2012
    #4