The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Techra M7: No Standby, No Access to Power Saver etc

    Discussion in 'Toshiba' started by JohnnX, Oct 26, 2007.

  1. JohnnX

    JohnnX Newbie

    Reputations:
    0
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    5
    Hi..

    I've just reinstalled XP back on my Techra M7 and cannot get access to the power saver control panel due to "no access rights" etc and not able to put it in Standby or Hybernation.. I have installed the common modules driver along with the basic XP Toshiba drivers but without luck..

    I've also gone through about 4 clean installs adding the drivers 1 by 1 first so as to try and resolve any conflicts.. also formatted the hard drive each time..

    I'm using Common Modules 24895A and Power Saver 24773B..

    It was fine before but I installed Vista on it for a while.. I got sick of Vista and its non stop dialog boxes etc and went back to XP.. now this is driving me crazy..

    Would anyone have any suggestions please?
     
    JohnnX, Oct 26, 2007
    #1