The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Tecra M4 - pinmod update failure, multiplier only x6

    Discussion in 'Toshiba' started by ex250, Mar 10, 2014.

  1. ex250

    ex250 Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    Hi,

    I was trying to uddate it with a little more power, it has a pentium mobile 740 (1.73ghz 533 bus) and reading about the pinmod, decided to purchase a p 735, 1.70ghz 400 bus to give a try and hit the 2.26ghz like a p780.

    I followed the guidelines on the Pin Modding and Overclocking a Pentium M Guide and system works, bus is on 533mhz, but limited to 800mhz (multiplier fixed to 6x) even running prime95.

    Bios has not much info to change, all is set to high perfomance... but no changes.

    Any body sorted this?

    Thanks in advance!
     
    ex250, Mar 10, 2014
    #1