The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    toshiba laptop powers down

    Discussion in 'Toshiba' started by MarzR83, Feb 28, 2012.

  1. MarzR83

    MarzR83 Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    I have a toshiba satelite L355D. I turn it on but when it tries to boot up but after a couple of seconds it shuts off, before i replaced the fan it would run for about 45mins, i thought that that was the problem. Can you help me out as to whats wrong with it.
     
  2. 1994F7PT

    1994F7PT Notebook Evangelist

    Reputations:
    247
    Messages:
    354
    Likes Received:
    0
    Trophy Points:
    30
    what did you remove when you stripped it down to replace the fan? sounds possibly like you've unseated the cpu heat sink and its shutting down to preserve itself
     
  3. imglidinhere

    imglidinhere Notebook Deity

    Reputations:
    387
    Messages:
    1,077
    Likes Received:
    59
    Trophy Points:
    66
    I agree with F7 above me. I think you should honestly check the machine again, take it apart and REALLY look at it. I was fortunate enough to make sure I reconnected everything properly. o.o
     
  4. MarzR83

    MarzR83 Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    The only thing I removed was the keyboard. I never went anywhere near the cpu or heat sink
     
  5. 1994F7PT

    1994F7PT Notebook Evangelist

    Reputations:
    247
    Messages:
    354
    Likes Received:
    0
    Trophy Points:
    30
    where was the fan located though? usually it is sat right on the heatsink and if the sink was disturbed and heat paste has dried out it could of cracked easily leading to overheating issues

    however after re-reading the original post, i'm not convinced and overheat is the issue as usually the laptop would run for a few minutes unless you have a very temp sensitive or high power cpu