The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    x205-sli1 blank screen when sli is enabled

    Discussion in 'Toshiba' started by nendren, Dec 20, 2008.

  1. nendren

    nendren Notebook Enthusiast

    Reputations:
    0
    Messages:
    41
    Likes Received:
    0
    Trophy Points:
    15
    When I click on enable sli my screen goes blank and when I reboot the screen will go blank. I have tried the newest drivers from Nvidia, a couple of different 180 drivers, and the 179.13 drivers and I get the same problem with all of them. They run fine until I enable SLI and the only way that I can get Vista to boot up is using System Restore. However, when I uninstall the drivers and use the original drivers (version number 7.15.11.5664) I can use SLI just fine. Does anyone know of any fix?


    I would rather wait to reinstall Vista until I receive my Vista Ultimate SP1 dvd, which should arrive in about a week.

    Edit: Forgot to mention that I recently installed 4gb of ram... if that makes any difference.
     
    nendren, Dec 20, 2008
    #1
  2. gammite

    gammite Notebook Geek

    Reputations:
    0
    Messages:
    86
    Likes Received:
    0
    Trophy Points:
    15
    ram shouldn't make any difference.

    where are you getting your drivers? if they are coming from laptopvideo2go i think that you modded .inf is off.
     
    gammite, Dec 22, 2008
    #2