The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    WTB CF-29 rubber feet, new handle, and TS

    Discussion in 'ToughBook Buy Sell and Trade Forum' started by interestingfellow, Dec 21, 2011.

  1. interestingfellow

    interestingfellow Notebook Deity

    Reputations:
    280
    Messages:
    995
    Likes Received:
    34
    Trophy Points:
    41
    I need to replace the feet on my 29, as well as the handle.

    Is there an off the shelf solution replacement for the rubber feet (yes,I could rig my own, but I dock mine everyday, and am concerned about stress on the dock/port connector.

    And I'm looking for a new handle assembly for my 29. the paint and snap lock on mine is wearing out (I might just rustoleum mine and add some thin washers)

    And I need to replace my TS glass, if anyone here has a good deal on a replacement, pm me. Yes, I have checked fleabay; i'm shopping around for the best deal before I buy.
     
    interestingfellow, Dec 21, 2011
    #1
  2. interestingfellow

    interestingfellow Notebook Deity

    Reputations:
    280
    Messages:
    995
    Likes Received:
    34
    Trophy Points:
    41
    I got it.
    Thanks techtuff!
     
    interestingfellow, Dec 29, 2011
    #2