The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Mother Board Connector

    Discussion in 'VAIO / Sony' started by anhgiang, Jun 29, 2013.

  1. anhgiang

    anhgiang Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    Hi all,

    I was trying to unlock/disconnect one of the connector from my Z720D's board and got stuck. I have no idea how to pull it off and was afraid I might damaged it if doing it wrong. Anybody, please, show me how to do it if you've done it before.

    [​IMG]

    TIA
     
    anhgiang, Jun 29, 2013
    #1
  2. urgiv

    urgiv Notebook Consultant

    Reputations:
    14
    Messages:
    203
    Likes Received:
    0
    Trophy Points:
    30
    really ? is not to difficultly, just hold so-rounding areas of connector and pull cable up
    [​IMG]


    I did hundreds of and no one broken. BTW what wrong wit your VGN-Z ?

    regards
     
    urgiv, Jun 30, 2013
    #2
  3. anhgiang

    anhgiang Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    Thank you very much! I'll try that later. I replaced the LCD and forgot to run that wire thru a hole. I figure disconnecting this end would be simpler than disassemble the screen.

    Once again, thank you!
     
    anhgiang, Jul 1, 2013
    #3
  4. anytimer

    anytimer Notebook Virtuoso

    Reputations:
    302
    Messages:
    2,160
    Likes Received:
    321
    Trophy Points:
    101
    Remember to disconnect the adapter and remove the battery before you do this.
     
    anytimer, Jul 1, 2013
    #4