The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Vaio Z13 - Native Command Queuing (NCQ)

    Discussion in 'VAIO / Sony' started by blowzy, Apr 4, 2012.

  1. blowzy

    blowzy Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    Hello,

    Confused :( I have Sony VAIO Z13 ( VPCZ13X9R/B ) with 2 x Toshiba SSD 64Gb on the board ( THNSNC064GMMJ ), maybe somebody know is there support of Native Command Queuing (NCQ) in the default RAID mode? After security erase and system restore Intel Rapid Storage shows that NCQ is disabled. As I remember it was enabled before manipulation with the drive.

    Is NCQ enabled by default on your Vaio Z with 2x ssd in the RAID mode?
    Any ideas how to turn it on?

    Thanks
     
    blowzy, Apr 4, 2012
    #1
  2. pyr0

    pyr0 100% laptop dynamite

    Reputations:
    829
    Messages:
    1,272
    Likes Received:
    36
    Trophy Points:
    56
    Here NCQ is enabled at all of the drives in the RAID array. Try to reinstall RST drivers.
     
    pyr0, Apr 4, 2012
    #2
  3. blowzy

    blowzy Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    thanks for your answer, but it does not help :-( maybe any additional ideas?
     
    blowzy, Apr 4, 2012
    #3