The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    replacing TZ screen

    Discussion in 'VAIO / Sony' started by work_permit, Feb 1, 2009.

  1. work_permit

    work_permit Notebook Enthusiast

    Reputations:
    0
    Messages:
    11
    Likes Received:
    0
    Trophy Points:
    5
    I need to replace the screen on my tz-295. I removed the bezel around the top and sides, and was able to remove the screen by disconnecting the LCD harness on the bottom. But I can't see any other connection, specifically for the power inverter.

    Does anyone know how the LCD gets power?
     
    work_permit, Feb 1, 2009
    #1
  2. ngvuanh

    ngvuanh Notebook Deity

    Reputations:
    288
    Messages:
    1,168
    Likes Received:
    31
    Trophy Points:
    66
    Take out the screen and you will see the video cable with a connector at lower left near the corner of the screen.
    The circuit board attached below the screen is controller and inverter board.
     
    ngvuanh, Feb 1, 2009
    #2