The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    anyone use rmclock for a 4850e or similar??

    Discussion in 'Windows OS and Software' started by zfactor, Dec 10, 2009.

  1. zfactor

    zfactor Mastershake

    Reputations:
    2,894
    Messages:
    11,134
    Likes Received:
    3
    Trophy Points:
    455
    i just did a upgrade for a freind to a 4850e in his acer from a a older single core. the system runs fine under normal use but is getting about 80 or so at full load under prime after about 20mins. i saw even 82 for a second.. imo to hot.

    first off rmclock will not recognize this cpu for some reason. but when i try to apply the settings no matter what voltage i use even if its default everything simply locks. i have to do a hard shutdown then restart and everything is normal again. i cant change even one voltage setting at any stepping even .001 or it locks up.

    os is win7 premium 64bit any thoughts??? thanks
     
    zfactor, Dec 10, 2009
    #1