The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.

M4600 Firepro M5950 Underclocking and Overclocking in 60Hz

Discussion in 'Dell Latitude, Vostro, and Precision' started by Ph0enix, Jun 25, 2012.

Thread Status:
Not open for further replies.
Page 2 of 2
  1. sodaant

    sodaant Notebook Enthusiast

    Reputations:
    0
    Messages:
    16
    Likes Received:
    0
    Trophy Points:
    5
    I haven't had any problems setting voltage, but I'm not exactly running stock. First, make sure to run ATI Tray Tools as admin, or a bunch of things don't work for some reason. I haven't had any problem with voltages, but there is a menu where you have to enable some things like higher/lower voltages/clocks.
     
    sodaant, Jun 29, 2012
    #11
  2. Ph0enix

    Ph0enix Notebook Consultant

    Reputations:
    104
    Messages:
    110
    Likes Received:
    0
    Trophy Points:
    30
    Voltage is fine, everything else isn't. Yeah I did install this with UAC off and I'm the Admin, the start-up issue is still there. I've unclocked the higher and lower voltage in the settings, check my previous post.

    My best overclocked set-up is 870MHz and 1100MHz, which sadly ATI Tray Tool cannot do.
     
    Ph0enix, Jun 30, 2012
    #12
Page 2 of 2
Thread Status:
Not open for further replies.

Share This Page