The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.

New Power Adapter

Discussion in 'Dell Latitude, Vostro, and Precision' started by simpson4, Nov 2, 2010.

Thread Status:
Not open for further replies.
  1. simpson4

    simpson4 Notebook Enthusiast

    Reputations:
    0
    Messages:
    10
    Likes Received:
    0
    Trophy Points:
    5
    I have a Dell Latitude E5510 laptop for work and I am thinking about getting another power adapter to keep at home and leave one in office.

    My question is the one that came with the laptop is 65W so would the 90W work?

    Replacement 90W Laptop AC Adapter(19.5V 4.62A/7.4*5.0), FREE Shipping, Replacement 90W Laptop AC Adapter(19.5V 4.62A/7.4*5.0)

    NEW
    type: Replacement new
    Output: 19.5V, 90 Watt, 4.62A
    Input: 100 - 240 V (worldwide use)
    Connector information: 7.4*5.0mm
    Power cord length: 3 ft

    EXISTING
    Output 19.5V 3,34A
    Input 100-240V 1.6A 50-60 Hz
     
  2. John Ratsey

    John Ratsey Moderately inquisitive Super Moderator

    Reputations:
    7,197
    Messages:
    28,839
    Likes Received:
    2,154
    Trophy Points:
    581
    90W will cause no problem: The computer only uses the power that it needs.

    John
     
  3. deathshots

    deathshots Newbie

    Reputations:
    0
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    5
    Just a heads up about the power brick. I'm using an Antec NP90 at school and the bios does not allow the E6410 to go above 1.1GHz, which is kind of annoying. Not sure if there's a way to get around different charger limitations short of hacking the bios.
     
  4. John Ratsey

    John Ratsey Moderately inquisitive Super Moderator

    Reputations:
    7,197
    Messages:
    28,839
    Likes Received:
    2,154
    Trophy Points:
    581
    The centre pin of the power connector allows the BIOS to interrogate a chip in the PSU which gives the power rating. If this chip is not present then the BIOS assumes that the PSU has insufficient power to let the CPU run at full speed.

    There is a work-around for this problem: Use RMClock or Throttlestop to override the CPU throttling. I used RMClock for this purpose during my first few months of E6400 ownership until Dell changed the BIOS to allow the E6400 with Intel GPU to run at full speed using a 65W PSU.

    John
     
  5. Robin24k

    Robin24k Notebook Deity

    Reputations:
    274
    Messages:
    1,700
    Likes Received:
    5
    Trophy Points:
    56
    Check Ebay for "Dell PA-3E", and be sure to get a genuine adapter though. You should be able to find one between $20 and $30.
     
Loading...
Thread Status:
Not open for further replies.

Share This Page