The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Acer Aspire 5112 WLMI bios

    Discussion in 'Acer' started by suraj, Aug 11, 2006.

  1. suraj

    suraj Notebook Evangelist

    Reputations:
    0
    Messages:
    311
    Likes Received:
    0
    Trophy Points:
    30
    hi
    i press f2 and i bios
    it went to Boot i changed som stuff now it an now i don remembar how it was from the beging i went to exit and chossed loade defult dan i went bake to boot
    it was written
    1 sata:ST9120 ect
    2ide
    3. Ide 0 :dvd drive
    4 PciBev : Realtek boot aget

    5Usb hdd
    6usb cdrom
    7Usb fdd
    8Usb Key

    but i remeber it was something like this 1 sata:ST9120 ect
    2. Ide 0 :dvd drive
    3 PciBev : Realtek boot aget
    4Ide:
    5Usb hdd
    6usb cdrom
    7Usb fdd
    8Usb Key
    ca´ne some one who one a 5112 or 5102 or any acer check ther and tell me
     
  2. suraj

    suraj Notebook Evangelist

    Reputations:
    0
    Messages:
    311
    Likes Received:
    0
    Trophy Points:
    30
    plz help me any one with acer laptop
    5112 or 5102 or any other
     
  3. nicolin

    nicolin Notebook Geek

    Reputations:
    0
    Messages:
    81
    Likes Received:
    0
    Trophy Points:
    15
    Why do you need to know the original configuration? Just set up the boot order as per your particular needs. The original configuration will not in any way give you better performance or the like...
     
  4. lewdvig

    lewdvig Notebook Virtuoso

    Reputations:
    1,049
    Messages:
    2,319
    Likes Received:
    26
    Trophy Points:
    66
    Or go into the BIOS and select 'load defaults' and then 'save & exit.'