The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Power Supply Question...PLEASE HELP!

    Discussion in 'Acer' started by Liza23, Dec 3, 2007.

  1. Liza23

    Liza23 Newbie

    Reputations:
    0
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    5
    I have an ACER Aspire 1690 and the power supply inside the notebook broke. I'm talking about the metal prong inside the notebook where you plug in your power cord.

    Can I replace that part separately or do I have to replace the entire mother board for that? Because I believe it is attached to the mother board. I kept the piece when it broker and fell out, so is there any way to sauter it back on?

    What do you recommend?

    Thank you! :(
     
    Liza23, Dec 3, 2007
    #1
  2. NotebookYoozer

    NotebookYoozer Notebook Evangelist

    Reputations:
    83
    Messages:
    536
    Likes Received:
    0
    Trophy Points:
    30
    it can be re-soldered if you are willing to take the risk or let a friend do it.

    a shop or Acer will probably try to sell you a replacement MB. don't do it.

    EDIT: sorry, if it's under warranty, i'd say send it in unless you don't want to be w/out your computer. if so, then it's DIY.
     
    NotebookYoozer, Dec 3, 2007
    #2
  3. Liza23

    Liza23 Newbie

    Reputations:
    0
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    5
    Thank you for your help! I really appreciate it. Liza
     
    Liza23, Dec 3, 2007
    #3
  4. NotebookYoozer

    NotebookYoozer Notebook Evangelist

    Reputations:
    83
    Messages:
    536
    Likes Received:
    0
    Trophy Points:
    30
    just remember that the soldering is a precision job, so take all necessary precautions.

    not trying to scare you into not doing it, just don't want you to be cavalier about it.
     
    NotebookYoozer, Dec 3, 2007
    #4
  5. Liza23

    Liza23 Newbie

    Reputations:
    0
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    5
    Absolutely!
     
    Liza23, Dec 3, 2007
    #5