The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    rmclock and the 1810tz

    Discussion in 'Acer' started by loudog3114, Dec 15, 2009.

  1. loudog3114

    loudog3114 Notebook Guru

    Reputations:
    0
    Messages:
    71
    Likes Received:
    0
    Trophy Points:
    15
    Has anyone else had luck undervolting and/or setting multipliers? So far, I am able to set the VID to .725 but it doesnt actually apply that VID. Also, I am only able to select from one multiplier, 6x. The highest is 6.5, which doesnt show.
     
    loudog3114, Dec 15, 2009
    #1
  2. loudog3114

    loudog3114 Notebook Guru

    Reputations:
    0
    Messages:
    71
    Likes Received:
    0
    Trophy Points:
    15
    nobody has attempted to use rmclock on the 1810?
     
    loudog3114, Dec 16, 2009
    #2